One of the myths: Only cut heavy winter, ignore summer cuts. This practice can easily lead to a summer tree full of apple trees and a vicious circle of scars in winter. In fact, the winter cut is the continuation of the summer cut, the summer cut is done well, and the winter cut has almost nothing to do. The timely summer cut can save a lot of nutrition and promote flower bud differentiation; if the summer cuts are put in place, the tree vigor is relatively stable, which can ensure high yield and stable production. Misunderstanding two: heavy cut light pull. That is, pulling branches late, open angle is not in place. At present, there is a widespread phenomenon of severe canopy closure in apple producing areas. The reason is that the laziness is too late and the angle is not open. The correct approach is that in the second year after planting, the base angle of the branch should be opened; when the length of the branch reaches 40% of the spacing, the branch should be pulled into 80 to 90 degrees in time, which is a good construction of the tree. The key to body structure. Misunderstanding 3: Can not afford to branch. Some trees have six or seven branches underneath. It was particularly crowded and the light deteriorated. As a result, the internal branches of the main branch were left to die. The result was a serious relocation of the site. The outside of the large branch had been stretched to the “illegal†space, causing a dilemma for the space to be left. To solve this problem, it is necessary to phase out, in batches, in accordance with the principle of "advancement of the inferior and eliminating the inferior," and to remove excess large branches and use the side branches of the remaining main branches to occupy space. The large branch with a base stem diameter greater than 1/2 of its diameter in the upper part of the canopy should also be updated in time, replacing the unilaterally extending twigs nearby. If it cannot be renewed, it is necessary to reconstruct the big branch, to open the corner of the "large side to stay weak," and to control its growth. In the summer, the ring is cut at its base to promote the germination of the basal bud, and the branch is gradually cultivated into a regenerating branch. Misunderstanding 4: The tree is too high and the trunk is too low. Trees that are too tall are generally 3 to 5 years old after they reach the full fruit period. They should drop their heads and adjust the tree height to 3 to 3.5 meters. Generally, they cannot be higher than 80% of the row spacing. The trunk height should generally be 60-80 cm. If it is too low, it should be gradually increased, replacing the lower branch with the upper branch. After the fruit trees are planted, they must select the appropriate site to retain the first layer of branches. The following are firmly erased to prevent future problems. Misunderstanding 5: The construction of the tree and the line spacing are not adapted. Planted dense, but the choice is a large crown tree, resulting in the existing row spacing can not accommodate the tree, the orchard has a severe canopy closure. This is also an important reason for the failure of dense planting in some orchards. To prevent this from happening, firstly, when designing an orchard, we should understand the characteristics of the varieties we are planting, choose suitable spacings, and forcibly use the Qiaoguan variety to plant dense plants. Without high technical support, it is difficult to succeed. The second is that in the shaping process, plastic surgery is strictly carried out according to the tree structure model suitable for dense planting. Now that there has been a phenomenon of depression, attention should be given to cultivating the new shoots that are issued on the trunk, and branches should be opened in time. After a certain number of short branches are formed, the long branches are removed in time. For large branches that cannot be renewed, on the one hand, the growth direction and angle should be adjusted. In the middle and posterior parts, the retracting lead branches should be cultivated, and the retraction should be carried out to circumcision to promote its front-end results. After the forces of growth, retract and remove the front end. Misunderstanding 6: The apple tree retracts the phenomenon of small depression. The retraction of the large branches can not be dumped, and the withdrawal of the small turtles can easily cause the branches to rejuvenate and cause the wound to heal. The thickness of the base left on the retraction site should not be less than 1/3 of the incision at the place of birth. Misunderstanding 7: Handle the improper handling of the cutting mouth. If the sparse annual branch is too high, it means that the branch has been severely short and severe, resulting in severe stripping in summer. When thinning, the cut should be close to the main branch or branch axis, the front part is slightly taller, the rear part is slightly lower, and the direction of the cut and the growth direction of the shoot is 10 degrees. For short cuts, the cut should be 0.5cm from the bud and slightly higher on the side of the bud, and do not leave too long. When sawing branches to stay too long, easy to make the wound infected dry rot, and cause the wound not easy to heal. Also note that when pruning or sawing branches, do not use too much force, otherwise it is easy to cause premature splitting of the branches or internal chapping, injuring the cortex and affecting wound healing. Pay attention to the fact that the thinning can not be excessive, otherwise it will seriously affect the branching potential and the tree potential. Misunderstanding 8: Instigated, short more. It was mainly due to the influence of sparsely planted giant tree pruning methods in the 1950s and 1960s. It was planted densely and planted trees, but it used the old techniques, resulting in an overcrowding that caused the tree to become strong and prosperous. For trees that use random headings, they should be replaced with slowness, appropriate thinning, emphasis on opening angles, with the summer ring cutting, circumcision measures, and promote its early results, with pressure on the crown. The results will be repaired later. Misunderstanding 9: "Tiger opens his mouth" and the lower "draw wedge". These two kinds of angle-opening methods are old and outdated methods, and are not suitable for the current dense planting and cultivation, in particular, they cannot be used for the susceptible strains of Fuji and Marshal. After the upper or lower opening is wounded, it is easy to infect the branch with trunk diseases, which quickly weakens the branches and loses the ability to produce results. Those who have adopted such a tactic should cultivate new renewed branches on the trunk as soon as possible, and promptly open their perspectives and replace the injured ones in due course. Misunderstanding 10: Scissors, saws are not sterilized. The prevalence of rot and dry rot has a lot to do with scissors and saw bacteria. Failure to pay attention to disinfection can cause serious consequences. The correct method is to remove the rot or dry rotten twigs and then immediately sterilize the pruning tools by fire or 5 times the 9281 sterilization; the cutting kerf should also be treated in time, which can be mixed with 1/15 thiophanate methyl Pure powder or sulphur powder oil smears the saw cut mouth. (Hengshui Taocheng District Forestry Bureau)
The beauty salon
enlarges the LED light and the LED eye cares your eyes. Light stability, no
flicker, high color rendering, high light transmittance, small light, soft
light is not glare, saving power. The 8x magnifier is helpful for nuanced
observation, blackheads, and acne. The water-filling base is firm and firm,
firmly grips the ground, is not easy to fall down, and is designed to be
leak-proof. It does not pass any power circuit and is safe and stable. It can
be equipped with optional rollers or bases without rollers. Compact and
exquisite appearance, easy to carry out.
Applicable to all kinds
of beauty places, such as tattoo, tattoo eyebrows, nail art, tattoo lips,
dental lighting crowded acne, micro-shaping and so on.
feature:
Beauty salon zoom LED lights can be bent freely, without restrictions to adjust the hose
Lamp head diameter is
20cm
LED light board
diameter is 18 cm
Magnifier diameter is
12 cm
Beauty Salon Magnifying LED Lamp Beauty Salon Magnifying LED Lamp,Portable LED Magnifying Lamp,LED Magnifying Floor Lamp,Beauty Salon LED Magnifying Lamp MING MEI ROYAL SPA FURNITURE , https://www.mingmeibeauty.com