Persimmon is completely off the astringent in the tree, convenient to eat, simple management, strong resistance and other characteristics, causing more and more attention of fruit growers and fruit merchants of all ages. To make the planting of persimmon persimmon scale, industrialization, and marketization, we now introduce to readers the essentials of grafting techniques for the breeding of sweet persimmon seedlings. Persimmon grafting uses woody buds. This method has wide adaptability, long grafting time, high speed, high survival rate, and conservation of scion. It is one of the most ideal grafting methods currently promoted. Grafting of sweet persimmons can be divided into three stages: spring, summer, and autumn throughout the year: Spring: From sprouting to sprouting, this is the period with the longest grafting time and the largest amount of grafting. The scion of this period is utilized. Branches cut in winter, precautions against loss of water during storage, this period of grafting must begin in the sap flow, seedling sprouts soon or just after germination, not earlier. Summer: Scion is a new twig that occurred in the spring. It is required that the scion should be cut in time, placed in a damp place, followed by picking, and used with it. During this period of high temperature and rainy weather, branches are not lignified, the utilization rate is low, and waste is large. Lagging is faced with high temperature and rain, and tannins are vigorous and vigorous. If the grafting technique is inexperienced and the speed is slow, the wound surface may be easily septumed and affect healing. Causes grafting to fail. After the above two phases have been completed, it is necessary to check the survival and cutting of the anvil in time, and to make up for the unaccepted ones, to supply enough water and fertilizer, and strive to return the nursery stocks. Fall: The seedlings of the seedlings are already thick and their branches are mature. Grafting needs to be completed before the seedlings are stopped, and an anvil cannot be cut afterwards. The specific time of the whole grafting process is based on local natural conditions, climate (phenology) and other factors, and it can be flexibly implemented. The entire grafting process requires: the grafting site is selected to be smooth from the ground (0-15 cm), and should not be too high. The orientation is selected on the windward side. The thickness of the root anvil and the scion are basically the same. Both sides of the graft are flat, straight, smooth, up and down, left and right, and the size is basically the same. After the grafting, they strive to expose white and white, do not hollow out, and do not leave seams. The bundled plastic has a narrow bandwidth, good elasticity, high flexibility, no bacteria and pollution, and the tying is strict, dense, tight and fast. Grafting blade is thin, flat, homogeneous and sharp, tough steel, skilled grafted personnel, flexible operation and fast speed.